Monday, October 4, 2010

Sound Operated Switch Project

Circuit diagram

 Notes:
This sensitive sound operated switch can be used with a dynamic microphone insert as above, or be used with an electret (ECM) microphone. If an ECM is used then R1 (shown dotted) will need to be included. A suitable value would be between 2.2k and 10kohms.
The two BC109C transitors form an audio preamp, the gain of which is controlled by the 10k preset. The output is further amplified by a BC182B transistor. To prevent instability the preamp is decoupled with a 100u capacitor and 1k resistor. The audio voltage at the collector of the BC182B is rectified by the two 1N4148 diodes and 4.7u capacitor. This dc voltage will
directly drive the BC212B transistor and operate the relay and LED.
It should be noted that this circuit does not "latch". The relay and LED operate momentarily in response to audio peaks.

web site: http://www.electronics-lab.com 

0 comments:

Post a Comment

Labels

About Me

My photo
I am an electrical and electronics engineering kathmandu university batch 2007
 
ELECTRICAL AND ELECTRONICS PROJECT COLLECTION. Design by Wpthemedesigner. Converted To Blogger Template By Anshul Tested by Blogger Templates.